Amplify ll Product Support

Our saunas are based on the infrared wavelength and not cabin temperature. Set to the desired temperature and allow the sauna to warm up for 45-60 minutes. The sauna heats up at an average of 1 degree per minute.

Follow these steps for proper warm up:

1. Make sure your sauna is plugged into a dedicated circuit installed by your electrician.
2. Set to the desired temperature and set time to 60 minutes
3. When turning sauna on for the first time, ensure each heater is active after a couple of minutes. If they are not, make sure connections are securely paired from their initial wire feed coming from the power box under the bench
4. Never fully cover the floor grate and heater with any obstruction that will not allow the heater to dissipate its heat.

You can also use the Reservation feature to turn your sauna on ahead of time.

NOTE: If your sauna is outside in an unheated garage, sunroom, basement, or patio, you may require additional time to warm the sauna up depending upon the temperature of the surrounding surface & room. REMEMBER, you are required to have an authorized Sunlighten cover over your sauna if it is outside or exposed to the weather in order to maintain your warranty.

The FS heater has a separate control that displays its heat intensity in three color codes: blue, green and red. Blue is the lowest intensity, and red is the maximum setting.

The Amplify series features SoloCarbon heaters that emit all three wavelengths of infrared, full-spectrum. Our patented technology has a highly emissive coating that delivers the highest quality AND quantity of infrared heat for therapeutic results. SoloCarbon panels are the only far infrared heaters clinically shown to raise the core body temperature nearly 3 degrees for the most detoxifying sweat and lower systolic and diastolic blood pressure.

With the unit ON, press the Temperature Up and Down keys simultaneously to toggle between Fahrenheit and Celsius.

The Bluetooth connectivity will be on the amplifier located in the unit's roof. There is a light indicator that’s labeled 'Bluetooth', this will show blue when something is connected to it.

To Pair your device with the sauna – Select the Bluetooth icon and search for “Sunlighten”. If you are prompted for a password, input password “0000”. You will now be connected to the Bluetooth Receiver in your new Sunlighten Sauna.

If your sauna has a stereo, it will not have an amplifier to connect with instead, the Bluetooth will pair to the stereo. When successfully paired, the BT mark will be displayed on the LCD.

Bluetooth function – Press the SRC button on the stereo to switch to BT mode. It will play a song from your phone automatically.

You can find your sauna serial number in multiple ways.

1. Serial number can be found on the tag attached to the door of your unit; if the unit is brand new.
2. Serial number can be found on the outside back wall of the unit near where the power cord is coming out.

Please refer to our installation guide using the link below: